Our table is able to move side to side and fore and aft but I don't think that it is currently able to go as far forward as it should. Side to side the limiting factor is the fixed part on the table frame butting up against where the screws screw up into the table but this isn't the case moving it forward.
this is the view with the table moved forward to the left and the photo below is of the table in the same forwad position but looking at the back mechanism
My feeling is that the table should be able to move forther forward (up in the picture abive) until the grey part of the frame is against the hole where the screw is.
Is this the case and if so how can I access the mechanism?
Thanks
Paddy
My feeling is that the table should be able to move forther forward (up in the picture abive) until the grey part of the frame is against the hole where the screw is.
Is this the case and if so how can I access the mechanism?
Thanks
Paddy