Fitting a new belly locker seal.

[Dafydd_Cymru]

Hi everyone trying to stop a leak.
The seal that was on it was as shown in the pic. It is for the belly locker to seal when the door presses against it. The u of the seal fits on a ridge going around the opening. In front of this ridge is another smaller ridge. Water has been leaking in from the outside and over the old seal. To the right of the picture on the right of the bulb is a line of rubber at the top and one at the bottom. Is this lower line supposed to go inside or outside the smaller ridge. I assume it goes outside to form a flat surface with the door? Many thanks! Apology for poor diagram.

 

[bobandjanie]

When we had a problem with our garage door, we contacted

Solve Your Sealing Problems | Rubber Seals and Trims

Seals Direct specialise in the manufacture and supply of rubber seals, trims and gaskets within the marine, industrial, caravan and automotive industries.

www.sealsdirect.co.uk

On our door there was two groves, so I wanted to fit a second seal, and they send an envelope with some samples in, I decided what one was best for the job and ordered it, good company to deal with. ? Bob.

 

[Manic]

Same as above I think.

Seals Direct | Solve Your Sealing Problems

Seals Direct specialise in the manufacture and supply of rubber seals, trims and gaskets within the marine, industrial, caravan and automotive industries.

www.sealsdirect.co.uk

found these on their website

 

[Dafydd_Cymru]

Good idea to ask them...cheers!