Hi
Im after some advice on how to replace our twin submersed water pump. We have had a look and it doesn't look too complicated but looks very fiddly so any tips pointers are welcome.
I am presuming that I will need to work from inside the water tank and push up the white wire from the Reich twin pump up through the small grey hole from inside out after having unscrewed the top part from the outside first.
Please correct me if this is wrong. Then I will need to fasten the hose inside the tank over the top part of the (water pump inside tank), I can see where this should go as the top part of the pump has snapped off leaving part connected to a hose with a screw bolt hose style fastener.
Once all is replaced I then hope to connect via the block connector and tape up as it was before I removed the tape in the image above.
Or should we pay someone? Hope it's not too fiddly.
I will await some advice, thanks
Im after some advice on how to replace our twin submersed water pump. We have had a look and it doesn't look too complicated but looks very fiddly so any tips pointers are welcome.
I am presuming that I will need to work from inside the water tank and push up the white wire from the Reich twin pump up through the small grey hole from inside out after having unscrewed the top part from the outside first.
Please correct me if this is wrong. Then I will need to fasten the hose inside the tank over the top part of the (water pump inside tank), I can see where this should go as the top part of the pump has snapped off leaving part connected to a hose with a screw bolt hose style fastener.
Once all is replaced I then hope to connect via the block connector and tape up as it was before I removed the tape in the image above.
Or should we pay someone? Hope it's not too fiddly.
I will await some advice, thanks