Puriclean

[Merdymort]

Hi, evidently the fresh water tank in my 2006 is a whopping 120L, (Rapido 7063f). If I want to use puriclean to clean the waterworks how little water can I use or do I actually need to completely fill the tank please?

 

[Two on Tour]

Instructions say to fill your tank and then leave to soak for 12 hours before pumping through each of your taps and outlets.
If you don't fill your tank then the Puriclean is not touching and acting on all the surfaces of your tank.

 

[jwells]

You could always partially fill the tank and drive around for a while to slosh the contents around! Then do the flushing!

 

[Two on Tour]

You could always partially fill the tank and drive around for a while to slosh the contents around! Then do the flushing!

Have you seen the price of diesel at the moment?

 

[Aspenshaw]

As said by Two on Tour. Just done my 140l tank. I clean the pipes etc by turning on the taps to pull through enough water. When the 12 hours over, I run some of the water into the waste tank. Fresh water is thrown on the garden or into the water bowser.

If you use the van regularly, you can probably get away with not doing it at all if you have a strong enough constitution.

In my manual, Hymer recommend cleaning the fresh water at the start and end of the season.

^{_{Subscribers  do not see these advertisements}}

 

[cyberyacht]

I give mine a swish round at the beginning of the season. When I had a yacht it was more problematic so it didn't get done. I survived.

 

[Merdymort]

As said by Two on Tour. Just done my 140l tank. I clean the pipes etc by turning on the taps to pull through enough water. When the 12 hours over, I run some of the water into the waste tank. Fresh water is thrown on the garden or into the water bowser.

If you use the van regularly, you can probably get away with not doing it at all if you have a strong enough constitution.

In my manual, Hymer recommend cleaning the fresh water at the start and end of the season.

Instructions say to fill your tank and then leave to soak for 12 hours before pumping through each of your taps and outlets.
If you don't fill your tank then the Puriclean is not touching and acting on all the surfaces of your tank.

Hmmm I thought you pulled it through all taps BEFORE leaving so those pipes get clean too??

 

[Two on Tour]

Hmmm I thought you pulled it through all taps BEFORE leaving so those pipes get clean too??

Yup, your right, had a senior moment reading off our pot of Puriclean.

 

[the1andonly]

Are you shure its 120l
My rapido book says 100l but only get about 65l in

 

[Merdymort]

Are you shure its 120l
My rapido book says 100l but only get about 65l in

Too late now the stuff is in it