How do I

[Al-Di]

how do I get the bulbs out of these,

 

[The Coops]

Number one put paper towel or like over bulb hold back of unit press in buld and turn anti clockwise
second one held in by spring clips very thin screwdriver in gap to ease apart loos like already been done once with markings on the thicker edge

 

[The Coops]

Must put glasses on BULB not blub ! Sorry!

 

[Carolyn and Kev]

The top one....Suction cup and twist and turn to pull out..Job done
The next one down is a pry out the entire Light assembly and change from behind . It looks like someone has tried to remove the lower section only looking at the marks on the lower lens bit? It needs removing entirely.

Kev

 

[Vipar]

I use a sucker and wear gloves.
You beat me too it

^{_{Subscribers  do not see these advertisements}}

 

[Carolyn and Kev]

Kev.......Top one!

 

[Manic]

For the second one, could be use a flat blade and lever it out.
please note I don’t know this just a suggestio.

 

[Dan and Jan]

how do I get the bulbs out of these,

View attachment 379220View attachment 379221View attachment 379222View attachment 379223

Call the REME like the old days. One case will do.

 

[Al-Di]

Thanks all for the input, will give it a go tomorrow,

 

[funflair]

View attachment 379228

Kev.......Top one!

That’s a GU10 240volts fitting, I think the OP,s is 12v and wil just be pis and pushed but usually has a lock ring.

^{_{Subscribers  do not see these advertisements}}

 

[9526]

The first two are probably bayonet (1/4 twist anti clockwise) the second two I’ve not seen before.

With the bayonet ones, the hardest thing is to get

Call the REME like the old days. One case will do. View attachment 379238

My brother is ex REME and I wouldn’t trust him within 100m of my van, particularly any of the glass/plastic bits

 

[DavidG58]

I am with Martin on first one, will most likely be an MR16 two pins, pull only if you twist they could snap

unless you know they only work on mains power then push and twist, as for the other suggest RTFM ?

 

[pappajohn]

View attachment 379228

Kev.......Top one!

That bulb is a GU10.. Mains voltage, twist and pull.
If its 12v it will be an MR11... Sucker on and just pull, its on plain pins.

 

[Silver-Fox]

Must put glasses on BULB not blub ! Sorry!

Or even a lamp ??

 

[Al-Di]

Update,
they are mr11 bulbs in torpedoes tried sucker didnt work so used a small nail file through the slots and eased them out,

2nd type a little more harder tried easing a thin blade down the side's no chance, finally used and old broken penknife(tip) and eased them out a little at a time from side to side, A small thin screwdriver would have worked but didnt have one to hand,

thanks again for all the input

^{_{Subscribers  do not see these advertisements}}