Cambelt change (1 Viewer)

[Camshaft]

Has anyone else replaced the cambelt on Fiat Ducato 2.8 1999?

 

[gus-lopez]

I think @Wildbill did his the other day; unfortunately after he had installed the engine.

 

[Camshaft]

whoops!! Just realized there are three types of belts all with different number of teeth on them???

^{_{Subscribers  do not see these advertisements}}

 

[Wildbill]

Has anyone else replaced the cambelt on Fiat Ducato 2.8 1999?

It's not hard to do if you know what your doing unless you know the history of the vehicle I would change the lot get a gates do not compromise
Make sure you get tight fitting pins to lock off the pump and crank timing
But if you have never done one don't have mechanic back ground I would get some to do it
Bill

 

[dave newell]

And all readily available from decent factors, once you've removed the old belt and tensioners check the details printed on the old belt, it will give No of teeth and belt width. There are two sets of tensioners as well, on later engines the tensioner and idler pulleys are slightly different sizes, on earlier ones they are the same.

D.

 

[Wildbill]

whoops!! Just realized there are three types of belts all with different number of teeth on them???

You will need you engin code don't take it off the vin plate get it off the engine
You never know it might have had a engine change
Bill

^{_{Subscribers  do not see these advertisements}}