Powerpart information

Joined
Feb 13, 2021
Posts
77
Likes collected
88
Location
Newport Pagnell
Funster No
79,207
MH
Buccaneer Commodore
Exp
Since 2018.
Can anyone help me with information, a manual, wiring diagram or wiring diagram for a Powerpart electrical system for my motorhome.
Powerpart are still trading but were unable or not willing to help me.
Some of the led's don't appear to work, I am ok with electrics but not really with electronics.
John
20200815_154004.jpg
20200815_154126.jpg
20200815_154021.jpg
 
Looking at it you appear to have a 13.8 volt stabilised power supply, the switch for the water pump where it says run should only light up when the pump is running. When you say the led’s don’t work do you mean the indicators led’s or the service they control? Top when pressed will show battery voltage, second amps being used if anything is turned on, third temp in the van, fourth outside temp, fifth fresh water level. Looks fairly old system, water levels were never very accurate or long lasting on a lot of vans, it looks as if the voltage one is ok. if you can carefully get the panel out it may be the earth is poor connection
 
Upvote 0
Looking at it you appear to have a 13.8 volt stabilised power supply, the switch for the water pump where it says run should only light up when the pump is running. When you say the led’s don’t work do you mean the indicators led’s or the service they control? Top when pressed will show battery voltage, second amps being used if anything is turned on, third temp in the van, fourth outside temp, fifth fresh water level. Looks fairly old system, water levels were never very accurate or long lasting on a lot of vans, it looks as if the voltage one is ok. if you can carefully get the panel out it may be the earth is poor connection
Thanks for reply. I don't know why, but having taken out a lot of electric cabling, I did find the pump supply had been budged (no fuse) on to a power cable, as had a few other circuits. I appreciate peoples best guesses as well as my own guesses, that is why I was looking for a user manual. As you say some circuits may or may not be used, or not working. As I rebuild the van I would like restore it to proper working (fused) order not bodged repairs.
The motorhome is a 2002 model. There are 2 rods in the fresh water tank, will check that there is a circuit there.
Thanks.
John
 
Upvote 0

Join us or log in to post a reply.

To join in you must be a member of MotorhomeFun

Join MotorhomeFun

Join us, it quick and easy!

Log in

Already a member? Log in here.

Latest journal entries

Back
Top