Omnistor 5002 Wind Out Awning Adjustment

Lizbiebrowne

LIFE MEMBER
Joined
Jun 1, 2020
Posts
568
Likes collected
823
Location
Teesside
Funster No
71,293
MH
Hymer B654
Exp
Since 2019.
The front piece (the metal housing that contains the legs and the end of the fabric that winds out when the awning is deployed) doesn't quite line up properly with the main body of the awning that's fixed to the van when I wind it in - its shifted about 5 mm towards the front of the van. If I loosen the arrowed bolt, and the corresponding bolt at the other end, should I be able to nudge it along a few mm?

IMG_5582.jpgIMG_5583.jpg
1715510346962.png
 
Sorry cannot help but you have reminded me to ask a related question.
When away recently the rear end of our Omnistore would not wind fully in, although the front did. Sorry haven’t got a photo and it is currently secured up with a cable tie so it was safe to continue journey.
Any help with that issue too is appreciated.
 
It's possibly as a result of the awning not winding in (tensioned) evenly parallel to the casing on the side.

Wonder if this helps?
 
Sorry cannot help but you have reminded me to ask a related question.
When away recently the rear end of our Omnistore would not wind fully in, although the front did. Sorry haven’t got a photo and it is currently secured up with a cable tie so it was safe to continue journey.
Any help with that issue too is appreciated.
Link I attached above might assist?
 
It's possibly as a result of the awning not winding in (tensioned) evenly parallel to the casing on the side.

Wonder if this helps?

Thanks, that was quick 😉I’ll look at that but it is a Fiamma.

Subscribers  do not see these advertisements

 
Just found Casper46 thread here but not sure that his final explanation in last pist much help 🤣
 

Join us or log in to post a reply.

To join in you must be a member of MotorhomeFun

Join MotorhomeFun

Join us, it quick and easy!

Log in

Already a member? Log in here.

Latest journal entries

Back
Top