Today I have fitted a solar panel to our Burstner I685. It's wired into a Schaudt LR1218 solar regulator then into a Schaudt EBL220 electroblok which is controlled by a Schaudt DT220 control panel.
I know I have power going into and out of the regulator and also as far as the 15amp fuse on the electroblok so I'm assuming all is good. The problem I have is that the control panel is showing nothing regarding the installation and it's supposed to.
I have done a bit of research and it would appear I need to enable "the solar current" on the DT220 control panel which includes a pin number. I have no idea how to do this but I have done a search on here and there is a lot written about Schaudt products so I was hoping someone has already done this. Any thoughts folks?
cheers
Stewart
I know I have power going into and out of the regulator and also as far as the 15amp fuse on the electroblok so I'm assuming all is good. The problem I have is that the control panel is showing nothing regarding the installation and it's supposed to.
I have done a bit of research and it would appear I need to enable "the solar current" on the DT220 control panel which includes a pin number. I have no idea how to do this but I have done a search on here and there is a lot written about Schaudt products so I was hoping someone has already done this. Any thoughts folks?
cheers
Stewart