Since it was a nice sunny day I thought I'd tackle the job of the refillable gas system, must say its a bit daunting drilling a hole in your brand new van I always remember though cut twice measure once or something like that.
Firstly stripped down the inside to make sure no cables or support beans in the way, the only small issue was the gas pipe prevents me from getting the filler at the exact same hight as the other two the fact they're not close to each other means it doesn't look out of place.
Spirit level through window so I can be sure my measurement is same inside as out.
Tape up and marked to save scratching or slipping.
Hole cut and wee lug holes cut top and bottom
Could get them the exact same hight due to internal gas pipe.
Birdseye view pipe comes into van in different locker then filler pipe runs along back of unit and inside of van before coming out at gas locker.
Firstly stripped down the inside to make sure no cables or support beans in the way, the only small issue was the gas pipe prevents me from getting the filler at the exact same hight as the other two the fact they're not close to each other means it doesn't look out of place.
Spirit level through window so I can be sure my measurement is same inside as out.
Tape up and marked to save scratching or slipping.
Hole cut and wee lug holes cut top and bottom
Could get them the exact same hight due to internal gas pipe.
Birdseye view pipe comes into van in different locker then filler pipe runs along back of unit and inside of van before coming out at gas locker.