Table not moving forwards

[Camdoon]

The table on my Matrix should be able to move in 3 directions from front to back, from side to side, and up and down.
It quite happily moves up and down (bit wobbly) and moves from side to side but is stuck unable to move towards the front of the van (towards the right in the photo). It is at its furthest back position. It would appear to be the black handle nearest which turns but that makes no difference - it is not apparent what it should do.
Any advice gratefully received

 

[Wombles]

Bump - can anyone advise or did you get this sorted Camdoon?

 

[DerryW]

You have released the cranked leaver ?

 

[Camdoon]

Bump - can anyone advise or did you get this sorted Camdoon?

I took the screws out to take the top off and it appeared to sort itself out by just moving the mechanism back and forth. It was a touchy wobbly so took the screws out the leg to detach it and tightened the inside leg screws - put it together again and all good.

 

[RandallC]

Try using sill slide or any silicon lubricant even mr sheen works well on the slides

^{_{Subscribers  do not see these advertisements}}

 

[Wombles]

I took the screws out to take the top off and it appeared to sort itself out by just moving the mechanism back and forth. It was a touchy wobbly so took the screws out the leg to detach it and tightened the inside leg screws - put it together again and all good.

That's good - your post may help others too with the same problem