Fresh water level sensor / probe

Joined
Aug 9, 2023
Posts
234
Likes collected
138
Location
Leeds, UK
Funster No
97,990
MH
Burstner T-Star
Hi

My fresh waster level don’t work on my 2005 Burstner. It’s stuck on 75% no matter how much water is in the tank.

I’ve tried everything following suggestions on older posts, take the probe out of the tank clean it, check/clean the connectors but nothing.

Hi do I check if it’s the probe not working?

Can I bridge the pins on the connector will this send a signal back to the screen/controller ?

Where can I find a direct replacement at a decent price ?

Thank you
 
Photos of the prone attached if tose helps ?

Thanks



IMG_7941.png

IMG_7938.png

IMG_7939.png

IMG_7940.png
 
Upvote 0
Use the wiring diagram from Peavy just puta link cable between the pins, brown and white should show full.
If the panel still shows 3/4 is time to get panel checked
 
Upvote 0
Hi

My fresh waster level don’t work on my 2005 Burstner. It’s stuck on 75% no matter how much water is in the tank.

I’ve tried everything following suggestions on older posts, take the probe out of the tank clean it, check/clean the connectors but nothing.

Hi do I check if it’s the probe not working?

Can I bridge the pins on the connector will this send a signal back to the screen/controller ?

Where can I find a direct replacement at a decent price ?

Thank you
Diabalo Dane replaced his tank sensors a few years ago with these https://www.tankblanket.co.uk/shop/ and reported back issue resolved.
 
Upvote 0
Upvote 0
Mine has lost the 50% reading completely but does seem to be 75% most of the time. Luckily with the Burstner on board tank a real easy job to eyeball the level.
 
Upvote 0

Join us or log in to post a reply.

To join in you must be a member of MotorhomeFun

Join MotorhomeFun

Join us, it quick and easy!

Log in

Already a member? Log in here.

Latest journal entries

Back
Top