Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
It just makes a beeping noise when trying to lower it.
Subscribers do not see these advertisements
Subscribers do not see these advertisements
My manual is the van which is in storage so I can't check.
However I have had a similar problem and I think there is combination of buttons you have to hold down for more than 5 seconds.
Sorry I can't be more help but I am suffering from CRS
Subscribers do not see these advertisements
Can't remember shitWhat is CRS?
The process I remember was vaguely like this but not as complex.From a previous thread - this is what Spidey used to sort her Chausson electric bed:
Enter in programming mode after having switched on the panel. To enter the programming mode, hold the hidden button (between the button UP and DOWN) and the button UP for 7 seconds. The green LED light with the symbol of the key switches on. If it doesn’t, repeat the operation.
Put underneath the bed some supports able to hold the bed in the lowest position.
Press the button UP; the bed descends. Let it rest on the supports and keep pushing until the bed starts raising again. Bring the bed up to its higher position and let it press the electric contact (limit switch).
Let the bed descend and start programming the positions (depending on the model of the bed can be 3 or 4 points). Let the bed descend to the first position, press the hidden button plus the button DOWN. The LED on the arrows will switch off and on again. Repeat with this procedure for the next 2-3 points and the system will automatically quit the programming mode.
Yours may not be the same kind of bed but hope it works for you
From a previous thread - this is what Spidey used to sort her Chausson electric bed:
Enter in programming mode after having switched on the panel. To enter the programming mode, hold the hidden button (between the button UP and DOWN) and the button UP for 7 seconds. The green LED light with the symbol of the key switches on. If it doesn’t, repeat the operation.
Put underneath the bed some supports able to hold the bed in the lowest position.
Press the button UP; the bed descends. Let it rest on the supports and keep pushing until the bed starts raising again. Bring the bed up to its higher position and let it press the electric contact (limit switch).
Let the bed descend and start programming the positions (depending on the model of the bed can be 3 or 4 points). Let the bed descend to the first position, press the hidden button plus the button DOWN. The LED on the arrows will switch off and on again. Repeat with this procedure for the next 2-3 points and the system will automatically quit the programming mode.
Yours may not be the same kind of bed but hope it works for you
[/QUOT
Subscribers do not see these advertisements
Subscribers do not see these advertisements