Hab door catch adjustment

[VXman]

The lower catch for the door (on the frame not the door itself) has become loose. I can see the 2 nuts to tighten/adjust but unable to access them.

It looks like if I removed the vertical frame (beige with the furry insulating stuff on) it would be easier to get at the nuts.

Any ideas how I might do this? -can't see any screws holding this bit of trim in.

 

[RobbyMClark]

Did mine a while ago, took the sliding mesh off via these little blanking caps, any thing similar??

 

[ctc]

There are box spanners with a slot cut in them which are used to attach cable ends to junction boxes, I have one for tightening satellite cable ends.

 

[VXman]

Did mine a while ago, took the sliding mesh off via these little blanking caps, any thing similar??
View attachment 597276View attachment 597277View attachment 597278View attachment 597279

Didn't notice anything but will have a look later.