Burstner no 12v

Joined
Sep 15, 2009
Posts
2,003
Likes collected
4,806
Location
Sussex coast
Funster No
8,475
MH
Lowline
Exp
learning
Popped into my van and the leisure Battery low warnig was beeping.
I turned a light on the only fluorescent in van it then went out I now have no 12v.

Any ideas?
 
I havn't a clue but last year.. 2020.. I had to have a new 'solenoid'.?? My battery 12v did same.
 
EBL low voltage cut off has shut down the system. If the battery has been that low for more than a couple of days battery will have had it.

Subscribers  do not see these advertisements

 
Well what a Pillock I was parking out the sun. Battery's appear to be holding a charge.
But that's last of my problems I opened up ebox cupboard and found my problem I removed wires of which I will provide pics. Replaced them and 12v now works. Clearly I have a problem and those are the fridge connections.
I suppose I better remove it and get it fixed.

Will I be OK to unpug those wires to use lights in van?
 
Should be.
The fridge cables are often a problem if the pin is not making good contact in the socket it arcs and the cable gets too hot & burns.

Not by any chance left the fridge on 12v as a lot of German vans with the fridge switched to 12v it runs off the hab battery, mine does.
 
Hi lenny forgot pic 2 sockets burnt one socket had pin stuck in it.

Here is pics I'm pretty sure fridge was turned off

IMG_20210108_162649.jpg IMG_20210108_162625.jpg IMG_20210108_162608.jpg
 
Oh it's a Reich not an EBL. Same principle applies, the contacts have been loose causing arcing, shouldn't cause any problems with the charging side.
Just need to cut the cables back a bit and fit new connectors, make sure they are a good tight fit when plugging them on.
Also worth opening the box and checking the connections on the blades as the cables have got hot they could have melted the soldered joints on the blades, may need resoldering.
 
Similar thing happened to my eBox in my Burstner on the fridge supply. The charred terminal may be just the tip of the iceberg :( The solder tracks on my circuit board and the Lucar pins had also burned out. Cost £350 for Apuljak to repair.
20180706_102615.jpg

Subscribers  do not see these advertisements

 
One of the jack pins pulled out socket too but like I said all is working OK.
But clearly problem on those burnt terminals.
Don't think I'm comfy trying to fix it myself so will send it to apuljack. I assume they can supply new plugs also.
Thanks for advice people
 
I doubled checked all was working today 12v wise everything was fine. I did not touch fridge though to be safe. The box came out OK not easy but better than I thought looking closely at plugs I'm lucky I still have a van.
I also remember last winter when in Holland on hook up my mains leed melted to hookup box. I wander if connected?
Both batteries appear to ha e survived thus far fingers crossed.

IMG_20210110_124625.jpg IMG_20210110_124653.jpg IMG_20210110_124700.jpg IMG_20210110_124646.jpg
 
Looks as you have been lucky Paul things could have been fatal, hope it all goes well for you.
 

Join us or log in to post a reply.

To join in you must be a member of MotorhomeFun

Join MotorhomeFun

Join us, it quick and easy!

Log in

Already a member? Log in here.

Latest journal entries

Back
Top