Sift
Free Member
Hello. My dining table converts into a double bed. The seat bases slide out to widen the bed area and the table drops down to fill the gap between the seats. My trouble is that when the seats are fully slid out and the cushions are placed (and fit nicely), holes are left near the wall of the MH. This means that in one seat the cushions are resting on the top of the water tank and on the other there is no support for the cushions at all - just a hole.
I think I must have some factory supplied wood panels / inserts missing, which would normally fit in the space vacated by the sliding seat bases.
Can anyone with this set up confirm whether there are factory supplied wooden panels please? And does anyone know where I might get them, or is it a case of DIY?
Cheers,
Lee.
I think I must have some factory supplied wood panels / inserts missing, which would normally fit in the space vacated by the sliding seat bases.
Can anyone with this set up confirm whether there are factory supplied wooden panels please? And does anyone know where I might get them, or is it a case of DIY?
Cheers,
Lee.