Truma 3002 - intermittent on gas! any suggestions

[ultimajk]

HI everyone,
I have a Truma 3002 and it has recently started going out when running on gas.
It lights fine but then goes out after a few minutes. It then tries to re-ignite, sometimes successfully, others not so. No real rhyme or reason.
Yesterday it worked fine for hours, today it worked for a few mins then went out.
Anything obvious i should be looking for?
many thanks
John

 

[irnbru]

At a guess...Faulty regulator, low temperature perhaps not gassing off properly?

 

[PDrill]

This is an ancient thread but as I had the same problem with my 3002 I thought I'd write about it here.

Started fine, ran for a few minutes, went off. No red light or anything else to start from. Happened also when EHU so no voltage wasn't an issue. After I installed a TV running on inverter (quick'n easy for that time) I noticed the inverter started beeping for low voltage when I moved inside the car. Panel showed ok voltage but still.

Turned out the main fuse was very loose on it's socket and after tightening no problems since. So a voltage problem it was even though it wasn't obvious at first.