Afternoon,
I have what I think is a strange grey waste outlet. It is presented on a rigid hose that has a thread on the end and it is 32mm diameter, but most bizarre is that it only sits about 6 inches off the ground, so I can't get a bucket under it.
So I was hoping to get some sort of fitting that would connect to the 32mm end and provide an extension using flexible hose. So far the best I have managed to come up with is a larger than 32mm flexible hose that I attach to the rigid hose and be held in place by a jubilee clip.
I could then put the other end of the hose in a bucket and the downward pressure would push the majority of the water up the pipe and in to the bucket.
Looking for a more elegant solution, any ideas?
I have what I think is a strange grey waste outlet. It is presented on a rigid hose that has a thread on the end and it is 32mm diameter, but most bizarre is that it only sits about 6 inches off the ground, so I can't get a bucket under it.
So I was hoping to get some sort of fitting that would connect to the 32mm end and provide an extension using flexible hose. So far the best I have managed to come up with is a larger than 32mm flexible hose that I attach to the rigid hose and be held in place by a jubilee clip.
I could then put the other end of the hose in a bucket and the downward pressure would push the majority of the water up the pipe and in to the bucket.
Looking for a more elegant solution, any ideas?