Solar Panel Connector

Discussion in 'Tech/Mech General' started by joemac, May 31, 2009.

  1. joemac

    joemac

    Joined:
    Aug 18, 2008
    Messages:
    25
    Location:
    Northants
    Ratings:
    +0
    Help!

    Can anyone tell me how to get a connector for a solar panel into an electroblock controller in a Hymer B774. The item I need is a Molex MLX (TM) power crimp housing, plug, 3 circuit in-line.

    I only want one of these and so far have only found a supplier for 20.


    Any ideas?

    Many thanks


    Joe
    (Biologist with an electronics engineer wife!):Eeek:
     
  2. Pronto

    Pronto

    Joined:
    Nov 17, 2007
    Messages:
    72
    Location:
    Lancashire
    Ratings:
    +0
    I've just wired a solar panel charge controller output into Block 7 on the EBL99 in my Hymer B524; this is a 2 pin connector and I can let you have one with the appropriate pins - PM me where to send them if they'll be of any use.

    Alternatively have a look at:

    MATE N LOCK Connectors

    where the connector housings come in packs of 5 and the pins in boxes of 50.
     
  3. joemac

    joemac

    Joined:
    Aug 18, 2008
    Messages:
    25
    Location:
    Northants
    Ratings:
    +0
    electroblock connector

    Hi Pronto,

    Many thanks for your kind offer, will send you the address when i learn how to pm.:Doh:
    We have block 7 free as well, and assume it takes the same connectors. Please send the same connector as you fitted on your Hymer.

    Thanks again

    Pam ( the engineer)
    via
    Joe ( the biologist)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice