Shaudt Frankia electrical Problems

[Portland]

We are now in Ireland, and in need of help the display is showing only 30 amps but 13v charge both leisure and motor batteries. Tried reset and get fault f1.11, I can't find it in the manual, also the display for solar is showing no voltage at panel but flashing if charging. Battery connections good.

 

[Stealaway]

What's it normally read?

 

[Portland]

176amp, have reset solar now getting charge but panel not correct,. Any fun Sterling know the procedure for 220DT panel

 

[Portland]

What's it normally read?

176amp I have reset solar and getting a charge but panel not correct, it's a 220dt do anyone know how to reset this

 

[Stealaway]

176amp I have reset solar and getting a charge but panel not correct, it's a 220dt do anyone know how to reset this

Search Electroblok 220 and solar in the fun search box. It has been covered previously

^{_{Subscribers  do not see these advertisements}}

 

[autorouter]

We are now in Ireland, and in need of help the display is showing only 30 amps but 13v charge both leisure and motor batteries. Tried reset and get fault f1.11, I can't find it in the manual, also the display for solar is showing no voltage at panel but flashing if charging. Battery connections good.

For clarity, do you mean the display says 30 amps (A) or 30 amp-hours (Ah)? Also what is the capacity of the leisure batteries? I'm guessing you have two 110Ah batteries.

When originally set up, the leisure battery Ah capacity would have to be entered into the display. The software then calculates 80% of that, to give you a margin so that when it reads zero there is still 20% left in the batteries. So for 220Ah of battery it would display 176Ah.

Maybe the display has somehow lost the setting, in which case it will revert to the factory setting which I think is a single battery of about 90Ah.

It would also be useful to know the amps going into/out of the battery, to be sure that the solar/mains charger is working OK. That will be a different display screen, which shows the volts and amps of each battery at that time.

If your display has somehow reverted to factory settings, maybe it has forgotten that the solar is connected and might need that resetting too. Sorry I don't know exactly how to do this, my panel is a different model.

 

[Portland]

For clarity, do you mean the display says 30 amps (A) or 30 amp-hours (Ah)? Also what is the capacity of the leisure batteries? I'm guessing you have two 110Ah batteries.

When originally set up, the leisure battery Ah capacity would have to be entered into the display. The software then calculates 80% of that, to give you a margin so that when it reads zero there is still 20% left in the batteries. So for 220Ah of battery it would display 176Ah.

Maybe the display has somehow lost the setting, in which case it will revert to the factory setting which I think is a single battery of about 90Ah.

It would also be useful to know the amps going into/out of the battery, to be sure that the solar/mains charger is working OK. That will be a different display screen, which shows the volts and amps of each battery at that time.

If your display has somehow reverted to factory settings, maybe it has forgotten that the solar is connected and might need that resetting too. Sorry I don't know exactly how to do this, my panel is a different model.

Thanks , does anyone know how to put system back to factory settings

 

[Hagstrom]

Download the Schaudt DT220 display panel manual - the instructions are in there....