Reversing Camera Advice (1 Viewer)

[Ed 57]

I want to fit a reversing camera to my Fiat Ducato PVC. I do not really want to drill holes in the van but have seen those that fit in rear brake light. As I use a towbar fitted cycle rack, would a rear tail light fitted camera see behond the cycle rack ?
Any advice would be welcome.
Ed

 

[Two on Tour]

The rear brake light type cameras are normally mounted in the high level stop light housing not in the lower tail,stop and indicator cluster.

 

[poppycamper]

Movano/Master vans have separate brake light low down on rear door so yes it would be blocked by cycle rack...HOWEVER I believe most if not all othet vans extra brake lights are right up on top of roof above rear doors so you should be fine

^{_{Subscribers  do not see these advertisements}}

 

[CamperManLez]

Mine is inclusive in the upper brake light and I see very well for around 10m back from the van. It has the distance grid as well. As for seeing beyond a cycle rack, yes it’s fine for that, I have a scooter rack fitted and carry a motor scooter. Bought the setup from Park cameras, good product, fit it yourself. You just need to be able to access the brake light holding bolts from inside the van. I can take a pic if its any use?

 

[CamperManLez]

Sorry it was Parkingcameras.com, good products

 

[David and Sally]

Ask this guy.

Very helpful

DRW Electronics, Rear View Camera Specialists

DRW Electronics specialize in rear view camera systems for cars, motorhomes, buses, taxis and trucks and carry large stocks from the simple basic systems up to the four camera systems with quad screen

www.drwelectronics.com

^{_{Subscribers  do not see these advertisements}}

 

[Jev88]

Ask this guy.

Very helpful

DRW Electronics, Rear View Camera Specialists

DRW Electronics specialize in rear view camera systems for cars, motorhomes, buses, taxis and trucks and carry large stocks from the simple basic systems up to the four camera systems with quad screen

www.drwelectronics.com

A second thumbs up for DRW.

 

[Ed 57]

Thank you for all the advice, I purchased from DRW and the owner could not have been more helpful. I fitted it today.

http://rearviewsystems.drwelectronics.com/rvs12.html

 

[PeteH]

I had an issue with one. When you braked at night it (the brake light) flooded the CMOS and you lost vision?.

^{_{Subscribers  do not see these advertisements}}

 

[Jev88]

I had an issue with one. When you braked at night it (the brake light) flooded the CMOS and you lost vision?.

I think the only solution is a shield on light or camera or to position further away.

 

[PeteH]

I think the only solution is a shield on light or camera or to position further away.

Yes, but if it is located IN the Light Fitting?. Mine was an early one. They may have come up with a solution by now. But it`s worth remembering. I suppose you could put a photo cell in the circuit and switch it (the light) out at night?.

 

[Jev88]

Yes, but if it is located IN the Light Fitting?. Mine was an early one. They may have come up with a solution by now. But it`s worth remembering.

Sorry. Forgot they did that model. My DRW was stand alone.

^{_{Subscribers  do not see these advertisements}}