Niks and Naks Table

[PaulandChrissy]

So today I finished building a 3D printed table on the dashboard of my Ducato based Motorhome. It’s complete with two phone holders. One for me and one for the better half. It’s irritated me for years that there’s no flat surfaces on the Ducato dash for bits and bobs. Problem solved with a bit of thought and the help of one of my 3D printers. Looking good I think.

Stay Safe everyone PaulandChrissy

 

[deleted79651]

So today I finished building a 3D printed table on the dashboard of my Ducato based Motorhome. It’s complete with two phone holders. One for me and one for the better half. It’s irritated me for years that there’s no flat surfaces on the Ducato dash for bits and bobs. Problem solved with a bit of thought and the help of one of my 3D printers. Looking good I think.

Stay Safe everyone PaulandChrissy

View attachment 542594

Hi Paul,

Are these going into production, and if so, how much? I presume that the 'Courier Clipboard' has to be removed, is that a lot of work, and will you supply a 'Total Idiot's Guide for the Mechanically Inept' [Basic Version] ...

Brunhilde is a June 2016 Model as per the Avatar picture.

Regards.

Steve

 

[PaulandChrissy]

High Steve.
The clipboard stays. I use it to clip the table in place so it’s removable. I’m not going to produce them, BUT. I will put the 3D cad designs in my resources section for funsters to download if they want to make one. It takes me far to long to make them. I will describe how I made it for funsters to copy if they fancy a challenge.

 

[PaulandChrissy]

The CAD files and instructions are now in my resources section if anyone would like them.

Stay Safe PaulandChrissy.