I would like to fit an outside "awning" type 12v LED light on my PVC and several people have commented on another thread suggesting I connect up to one of the existing lights in a cupboard right next to where the new exterior light is going to be fitted. I obviously will need a switch as well.
So can anyone set out in simple terms how to wire it up. In terms of load, all the fittings in the van had Halogen bulbs but these were all replaced with LED bulbs when I bought the van. I'm quite happy soldering and following instructions but need help with the specific wiring diagram and is it ok to get the feed from the rear of an existing fitting and where do I pick up the ground/neutral from?
Many thanks
Simon
So can anyone set out in simple terms how to wire it up. In terms of load, all the fittings in the van had Halogen bulbs but these were all replaced with LED bulbs when I bought the van. I'm quite happy soldering and following instructions but need help with the specific wiring diagram and is it ok to get the feed from the rear of an existing fitting and where do I pick up the ground/neutral from?
Many thanks
Simon