Tincataylor
Free Member
- Jul 9, 2012
- 639
- 1,360
- Funster No
- 21,869
- MH
- Coachbuilt
- Exp
- Never leave a campsite with your clothes line tied to a lamp post.
This was going to be an easy fix, or so I thought but it has turned into a bit of a problem. On our A/S Nuevo the female half of the gas locker door stay is fixed to the side of the camper with two screws, that accepts the male half that is fixed to the locker door. The purpose of the whole thing being to keep the locker door in the open / upright position while the user is accessing the locker. Over time these screws have become loose and it is not possible to tighten them as the holes in the side of the van no longer have enough "meat". A larger diameter screw is not really an option as the existing ones are about as big as you can go with such a short screw. I thought pop rivets would be the answer, but once again the side panel of the van is not strong enough and they popped out with very little effort. It would be a simple matter to replace the self tapping screws with a machine screw and nut if it were not for the fact that the van side is double skinned.
I am coming to the opinion that I will have to strip away the lining inside and then drill a hole large enough for a nut to pass through and then affect the aforementioned repair. Naturally I am loathe to do this; do any of you bright people have a better idea?
One last thought, could I blank the existing hole off by bonding a round piece of plastic the size of the existing holes (or possibly bigger) and then drill a smaller hole and then re-fit the bracket with smaller screws? If this is an option what adhesive have people found best when working with GRP
Many thanks in advance for any suggestions you may be able to come up with,
Tinca
I am coming to the opinion that I will have to strip away the lining inside and then drill a hole large enough for a nut to pass through and then affect the aforementioned repair. Naturally I am loathe to do this; do any of you bright people have a better idea?
One last thought, could I blank the existing hole off by bonding a round piece of plastic the size of the existing holes (or possibly bigger) and then drill a smaller hole and then re-fit the bracket with smaller screws? If this is an option what adhesive have people found best when working with GRP
Many thanks in advance for any suggestions you may be able to come up with,
Tinca