Eberspacher inton truma ducting (1 Viewer)

[Davylambretta]

Anyone whos fitted an eberspacher or webasto unit to their van did you tie the system into your existing truma ducting and if sonwhat did you use and how was the results?

 

[andy63]

If you are fitting another heat source to your van ie replacing the truma gas with a diesel air heater then the existing ducting would be fine to use...
I have fitted a diesel heater but it was an original fit and not a replacement so came with the ducting and fittings...
Andy

 

[Davylambretta]

Planning on adding it into the current setup which has a truma combi boiler either the 4000 or 6000 might not be able to utilise all the vents due to the boiler system but will mean reduced running costs and if one goats tits up still got heating

^{_{Subscribers  do not see these advertisements}}

 

[andy63]

It should still be possible... what's involved will depend on how many heater outlets your existing boiler has and keeping the connections from the diesel healer outlets to the existing system as short as possible..

 

[Davylambretta]

That's not a problem as can tie in from under the seat main concern is the boiler as say 50/50 heat distribution from it not sure if the blown air from the ebber will pass through it OK