cap for chair swivel lever missing (1 Viewer)

[Millie's Mum and Dad]

Can anyone help please. We have a 2008 Swift Bolero. The lever that you pull to swivel the driver and passenger seats round has lost its black plastic cap (and the other one is cracked so keeps falling off), leaving a nasty metal lever that's very awkward to pull.
Does anyone know where we can buy replacements?
Thanks

 

[funflair]

I would be tempted to make something out of two bits of wood shaped a bit to take the metalwork and then sandwiched either side with some epoxy or similar adhesive.

But I am from Yorkshire my wife keeps pointing out.

Martin

 

[scotzsue]

also need some but this much for a bit of plastic, think I might just use a load of gaffer tape over foam.

^{_{Subscribers  do not see these advertisements}}

 

[Millie's Mum and Dad]

I would be tempted to make something out of two bits of wood shaped a bit to take the metalwork and then sandwiched either side with some epoxy or similar adhesive

That's exactly what hubby suggested!

Thanks guys. At least I know where to look now.

 

[golly]

There was a similar thread a while ago with some suggestions. http://www.motorhomefun.co.uk/forum...t-operating-lever-handle.148011/#post-2241644

 

[Sheddy]

Mould your own using Instamorph plastic available on eBay
Cheers
Ed

^{_{Subscribers  do not see these advertisements}}

 

[pyro]

You can buy adhesive lined heat shrink sleeving like the one below. Cut into lengths, put one on, run the hairdrier over it, then do the same again. Job's a giid in

Amazon product ASIN B00I1JCUVO
Alternatively do what one b*****d and steal them off a MH on a showroom forecourt. That's what happened to us, and the dealer had to replace them