Aluminium Extrusion for RV Roof (1 Viewer)

[American Dream]

I am trying to source the aluminium extrusion strip that runs right around both the sides of the roof and walls.It has the white "filler strip".

I got some good leads and found a supplier for the EPDM rubber sheeting.:thumb:

I wonder if someone on this forum can come up trumps again.

 

[Geo]

I knew I had seen it somewhere before, a good selection too
Link Removed
Geo

 

[Gonewiththewind]

I have been trying to sauce this strip all weekend due to an altication with an ungiving tree branch to the front corner of the luton.
Just one question, does said extrusion bend easy or is it normaly shaped. Only slight damage, I beleive that the panel can be sorted but was looking at replacing the strip.

Don

^{_{Subscribers  do not see these advertisements}}

 

[American Dream]

I knew I had seen it somewhere before, a good selection too
Link Removed
Geo

:thumb::thumb::thumb:Brilliant Geo. Many Thanks. :thumb::thumb::thumb:

 

[Geo]

I have been trying to sauce this strip all weekend due to an altication with an ungiving tree branch to the front corner of the luton.
Just one question, does said extrusion bend easy or is it normaly shaped. Only slight damage, I beleive that the panel can be sorted but was looking at replacing the strip.

Don

Sorry Don it dont come shaped, very carefull manipulation is the word i would use
Geo

 

[Peter JohnsCross MH]

Sorry Don it dont come shaped, very carefull manipulation is the word i would use
Geo

Like a woman!:thumb:

----------------------------------​

Must admit the knowledge on FUN is brilliant, straight to the point instead of a load of waffle elsewhere.

How about a section called 'Find It' with all these usefull links posted in there?

^{_{Subscribers  do not see these advertisements}}

 

[Geo]

Like a woman!:thumb:

----------------------------------​

Must admit the knowledge on FUN is brilliant, straight to the point instead of a load of waffle elsewhere.

How about a section called 'Find It' with all these usefull links posted in there?

Not quite mate, the extrusion eventually gives in and bends
Geo