- Jun 24, 2020
- 43
- 15
- Funster No
- 72,173
- MH
- Hymer Starline B690
- Exp
- Since July 2020
Morning all,
I have a 2013 Hymer with GRP sheets on the roof and will shortly be fitting a Poynting 2in1 Mimo.
The antenna comes with a longer spigot but a quick measurement looks like it maybe too short. It comes with an adhesive pad which seems to be the option for a non-drilled flush mount, however as a belt & braces approach I would like to clamp on the spigot on the inside as well as using the adhesive pad.
In short (finally), can anyone recommend a 3D scanning and printing service to make a longer spigot (Ideally in the Gloucestershire area) or another means to extend the length of the spigot (without widening the existing hole in the roof)?
Thanks
I have a 2013 Hymer with GRP sheets on the roof and will shortly be fitting a Poynting 2in1 Mimo.
The antenna comes with a longer spigot but a quick measurement looks like it maybe too short. It comes with an adhesive pad which seems to be the option for a non-drilled flush mount, however as a belt & braces approach I would like to clamp on the spigot on the inside as well as using the adhesive pad.
In short (finally), can anyone recommend a 3D scanning and printing service to make a longer spigot (Ideally in the Gloucestershire area) or another means to extend the length of the spigot (without widening the existing hole in the roof)?
Thanks