- Jul 1, 2010
- 3,198
- 33,470
- Funster No
- 12,394
- MH
- Hymer B 588 DL
- Exp
- Since September 2010
Have fitted an external satellite connection for my Multimo dish along with additional 12vdc & 230vac socket outlets (both the latter in the PSU locker) on my 2013 Mohawk.
I can feed the sat receiver output via a long cable to the AV 1 socket on factory fit media centre (below screen LH front) but this looks very unsightly. Behind the PSU there are 3 spare RCA plugs Audio L, Audio R and Video all marked for AV2. The audio plugs are obviously connected to the media centre as I can play sound through them, the video however does not work so assume its disconnected and AV2 on unit is used for the factory fitted reversing camera.
Has anyone retrofitted a sat system and if so how did you get a video signal to the media centre? I'm guessing I'll have to take it out and fit a splitter to the AV2 socket and connect both the camera and AV2 video leads.
Advice or suggestions welcome if I'm barking up the wrong tree.
If anyone else is contemplating fitting extra sockets as I did I'll start a thread with photo's of the project in the next couple of days. It was suprisingly straightforward and the assistance and advice I received from Dan Howlett the design and support technician at Sargents was outstanding. :thumb::thumb::thumb:
Photo of completed project which if I do say looks the business, the coax socket is also connected externally for those sites where freeview reception is rubbish and plug ins are provided usually on the EHU post.
I can feed the sat receiver output via a long cable to the AV 1 socket on factory fit media centre (below screen LH front) but this looks very unsightly. Behind the PSU there are 3 spare RCA plugs Audio L, Audio R and Video all marked for AV2. The audio plugs are obviously connected to the media centre as I can play sound through them, the video however does not work so assume its disconnected and AV2 on unit is used for the factory fitted reversing camera.
Has anyone retrofitted a sat system and if so how did you get a video signal to the media centre? I'm guessing I'll have to take it out and fit a splitter to the AV2 socket and connect both the camera and AV2 video leads.
Advice or suggestions welcome if I'm barking up the wrong tree.
If anyone else is contemplating fitting extra sockets as I did I'll start a thread with photo's of the project in the next couple of days. It was suprisingly straightforward and the assistance and advice I received from Dan Howlett the design and support technician at Sargents was outstanding. :thumb::thumb::thumb:
Photo of completed project which if I do say looks the business, the coax socket is also connected externally for those sites where freeview reception is rubbish and plug ins are provided usually on the EHU post.