- Feb 24, 2013
- 13,051
- 101,381
- Funster No
- 24,833
- MH
- Hymer S800
- Exp
- not long enough
Just pulled MH out ready for weekend away, disconnected mains before moving, started engine, control panel beeping, we have had a few issues with step sensor, but went back to check, telling me mains hook up still connected
I can clearly see lead on floor in mirror!!
I did once start up without disconnecting, you then have to stop engine, disconnect and restart otherwise it does not recognise the disconnection, I found out by trial and error
This time though it was definitely disconnected before starting up, yet the display still shows the connected icon, (no line through the lead). managed to fool it by tripping the RCD, turning engine off and restarting
Hopefully it will not happen again, but any ideas what might be wrong? I fear it might start beeping mid journey and there is no mute option as we found out with the step issue on a 300 mile journey back from Scotland!!
Apart from throw away the too clever for its own good controller!!
I can clearly see lead on floor in mirror!!
I did once start up without disconnecting, you then have to stop engine, disconnect and restart otherwise it does not recognise the disconnection, I found out by trial and error
This time though it was definitely disconnected before starting up, yet the display still shows the connected icon, (no line through the lead). managed to fool it by tripping the RCD, turning engine off and restarting
Hopefully it will not happen again, but any ideas what might be wrong? I fear it might start beeping mid journey and there is no mute option as we found out with the step issue on a 300 mile journey back from Scotland!!
Apart from throw away the too clever for its own good controller!!