hi i am having problems bleeding the injector after an engine rebuild any help appreciated thanks
bill:helpsos:
bill:helpsos:
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Subscribers do not see these advertisements
thanks that's wat i have been doing but it seems the pump not getting fuel never had problem like i have had with thisProbably cannot help you as only ever had to bleed old tractors but we used to crack open the pipes at the pump and crank it over and then un do each injector pipe in turn and crank it again until it fired up-----This info is probably 30 years behind times
Subscribers do not see these advertisements
will look tomorrow probably air lock thanks for posting :thumb:There should be a bleed screw on it some where
There should be a bleed screw on it some where
Subscribers do not see these advertisements
it's a brand new engine almost won hurt it will itBill is there a small bleed screw on the top of the pump? If so bleed by unscrewing a little and turn over while priming to bleed the pump then do the injectors if it will not start you could try easystart to just start it a couple of times and pull the fuel through
Subscribers do not see these advertisements