slobadoberbob
Free Member
- Jun 1, 2009
- 6,151
- 1,960
- Funster No
- 6,953
- MH
- Winnebago 23' something
- Exp
- 25 years & counting
I have noticed over this winter that a mark appeared round the edge of the rear wheel arch of my Winnebago Aspect.. only on the habitation door side. It looked like a rusty mark all the way round.. As the RV is all fibreglass I knew that was not the issue.. I found that it is like a hold mark under a film of plastic.. the plastic is bit like those you find protecting area on new appliances.. however this would not peel off.. it was obviously put on at the Winnebago factory when they fitted the outer wheel arch mouldings... with great care and 3 hours of work I have now managed to remove this plastic see through covering.. the marks have all now gone and it looks good even if I say so myself.. funny it was only on one side of the RV.
It is that time of the year I am doing all the little jobs before the season starts.. I needed to repaint the Reece tow ball where the new roller wheel was fitted by a friend on RVOC.. got some surface rust, so a quick lick of paint sorted that.. Found a couple other little jobs that needed doing and I am now ready to re load water etc., not to long before we use it again...
Bob:thumb: so what have you just done?
It is that time of the year I am doing all the little jobs before the season starts.. I needed to repaint the Reece tow ball where the new roller wheel was fitted by a friend on RVOC.. got some surface rust, so a quick lick of paint sorted that.. Found a couple other little jobs that needed doing and I am now ready to re load water etc., not to long before we use it again...
Bob:thumb: so what have you just done?