Hymer B644 sink (1 Viewer)

[mikekaren2]

Hi, my Hymer B644 kitchen sink waste trap is leaking slightly, I suspect that the screw on Trap base seal needs renewing, a easy job but I wonder if anyone has bought one and if so where did they get it from. I'm not sure if the part is specific to Hymer or if they are a standard plumbing part, any ideas?

The trap is similar to the one in the picture.

 

[wizza]

I had the same problem on my 544 I replaced with the one you have in the picture, came from brown hills off their eBay page.

 

[mikekaren2]

I had the same problem on my 544 I replaced with the one you have in the picture, came from brown hills off their eBay page.

Wizza, when you changed it does the new one fit the pipe work by screwing in pushfit or glued, is it straight forward to do.

Mike

^{_{Subscribers  do not see these advertisements}}

 

[JeanLuc]

It's a bayonet fit that pulls into place on mine. More than two locating lugs though I seem to remember.

 

[wizza]

I tried a new seal and it still leaked so i removed the old one mine just pulled off then i measured the pipe for the drain and bought one off ebay mine is a 1996 b544, and just used the chrome plug off my old waste not cheap about £20 pound
Item no 181534909025

 

[Manic]

I had to replace both my sink drains , also got from Brownhills eBay.
It just slid on pipe with silicon to seal.

^{_{Subscribers  do not see these advertisements}}