This is for all those people I see fighting with a flexible funnel in one hand and a container of water in the other. This will hopefully make the whole water filling job a lot easier. 3D printed in food safe PETG grey/black plastic. Will slot straight into the European/British water filler neck. External diameter of the funnel pipe is 33mm, 29mm, or 23mm. Please check your filler neck doesn’t have any smaller diameter restrictions preventing insertion. Van tested on was Auto Trail and was 33mm. Smaller diameters can be made on request. Standard models are 33mm, 29mm or 23mm external diameter pipe, 90mm long inclined at 15degrees. By far, the most popular diameter has been 33mm
MEASURING TIP
I recommend putting a pipe/tube into you filler neck, gradually increasing the diameter with some masking or gaffer tape until it fits in the hole snug, it’s now easier to measure the diameter of your pole rather than the filler neck itself. Let me know that diameter and I will make it 1mm smaller. The funnel pipe length is 90mm, so smaller restrictions as the neck bends deeper in will not affect its fitting. I will assume 15degree slope unless informed to the contrary.
Cost is £9.50 + p&p of £3.20.
chrisatheathpark@yahoo.com
MEASURING TIP
I recommend putting a pipe/tube into you filler neck, gradually increasing the diameter with some masking or gaffer tape until it fits in the hole snug, it’s now easier to measure the diameter of your pole rather than the filler neck itself. Let me know that diameter and I will make it 1mm smaller. The funnel pipe length is 90mm, so smaller restrictions as the neck bends deeper in will not affect its fitting. I will assume 15degree slope unless informed to the contrary.
Cost is £9.50 + p&p of £3.20.
chrisatheathpark@yahoo.com