Wind shield for Cadac (1 Viewer)

[Suda]

Hello. Has anyone located a windshield to use with a table top Cadac BBQ ?
I have trawled Amazon and EBay but the ones there are too short and only made for Backpackers with a small spirit stove. The French seem to have one that is sturdy and has 3 hinged panels. Thanks

 

[Wickolad]

Have look at this
http://pages.ebay.com/link/?nav=item.view&alt=web&id=381078866154

10 PCS Plates Design--100% brand new and high quality. Built in pegs to ensure wind shield fixed into ground firmly. A must have one for any outdoor camping cooking.
Size: 24cm x 8.5cm x 1cm (fold); 24cm x 83cm x 0.1cm (unfold).
Material: aluminum Color: Silver

 

[Wickolad]

The thing I do is put a windbreak up around the table on 3 sides then stand or sit at open side to cook. If wind quite strong I use the Aluminium blocker around the stove as well.

^{_{Subscribers  do not see these advertisements}}

 

[Suda]

Thanks Wickolad, but it does not have the height. I assume the 83cms. is when the 10 plates are fully opened. I would need at least 40 cm high panels to cope with the height of the legs as well as the gas burner and the pan on top!!

 

[andeb]

@ Suda - if I am not mistaken the ones that the French use are those which they have had locally manufactured in Morocco, which is where we get ours made.

 

[hilldweller]

Hello. Has anyone located a windshield to use with a table top Cadac BBQ ?

Yes indeed. CAROL of Chester fame has the perfect guard. I borrowed it once and cooked a whole pig on the Cadac in one minute thirty seconds. PM her a begging request for her source.

^{_{Subscribers  do not see these advertisements}}

 

[Wickolad]

Same company does the identical item a bit cheaper....
http://pages.ebay.com/link/?nav=item.view&alt=web&id=381078866432
At this price, why not buy 2, 2nd is 5% cheaper and with very basic fabrication or alteration, ie wire rod, link/stack them. You then have your height and total cost less than £10. Its also very flexible to work with round or square/ oblong shaped burners.

 

[TheBig1]

any competent diy'er or metal worker could hinge 3 or4 pieces of aluminium sheet to make a wind shield. when not in use it would fold flat