Well off again tomorrow to pick up the van (1 Viewer)

[Madmark62]

As some may have read we had an interseting time when we went to pick up our LeSharo a couple of weeks ago.
Well tomorrow we are off again and this time I am certain there will be no more problems:thumb:.
The van has been sorted out and at a very reasonable charge. If any one needs anything sorting with their van around the Gloucester south area, near junction 12 M5, then
G&M Motors
Old Airfield Farm
Moreton Valence
Gloucester
GL2 7NG
are the ones for you.

Hopefully all will go to plan and we will have a nice trouble free run home

 

[icantremember]

Good luck Mark.......hope all goes well tomorrow:thumb:

 

[chatter]

good luck, hope this is the start of many happy years rving

^{_{Subscribers  do not see these advertisements}}

 

[bobandjanie]

Good luck Mark, lets hope the next chapter is better than the first.:thumb: Bob.

 

[Madmark62]

Thanks everyone .

Really looking forward to getting her home and I can then start to do a few things .
Rightio off to feather, early start in the morning.

 

[Jim]

Have a problem free trip and have fun:thumb:

^{_{Subscribers  do not see these advertisements}}

 

[Ralph-n-Bev]

Good luck , sure everything will be ok, this time:thumb:

 

[Madmark62]

Well got back in one piece, no dramas or any problems what so ever.
Nice and steady run 55-60mph, the only problem with the van was the driver.

The van a bit under powered but never missed a beat, 2.1 turbo diesel Renault trafic 1985 engine, pulling 3 ton is always going to struggle for power though.

Now for the work to begin, got some rust on the cab area, but nothing too major. Wire wheel on drill, rubbed down, treated with Vacxtan and thyen primes and then painted, easy!!!

 

[motorhomelover]

Well got back in one piece, no dramas or any problems what so ever.
Nice and steady run 55-60mph, the only problem with the van was the driver.

The van a bit under powered but never missed a beat, 2.1 turbo diesel Renault trafic 1985 engine, pulling 3 ton is always going to struggle for power though.

Now for the work to begin, got some rust on the cab area, but nothing too major. Wire wheel on drill, rubbed down, treated with Vacxtan and thyen primes and then painted, easy!!!

photos please

^{_{Subscribers  do not see these advertisements}}

 

[Madmark62]

photos please

I have uploaded a couple of pics into an album.