Water Pump (1 Viewer)

[johnp10]

May have been covered on other threads, but I cant find it.
Sooo...water pump on my MH is a Fiamma SF 126 Pro.
When switched on at the switch board it runs, but runs contiually, even when all taps, boiler, etc. are fully primed.
I cant find any screws on it to adjust the pressure, as was mentioned in another thread.
Is it an ex pump? Is it defunct? Does it need a replacement?
MH is 1998, so I assume it's the original pump.
Looks like a 10 minute job to replace.
Any advice?
Cheers
John

 

[Peter JohnsCross MH]

Hi,

You will more than lileky find the pressure micro switch is stuck, it on the bottom of the pump and will have a push on electrical connector on either side.

Replaceble spare part, I know we stock them but cant find it on website! Just give us a ring

Peter

 

[johnp10]

Thanks Peter.
I'll have a look tomorrow If I'm sober and out of bed.
(See the pub prices thread).
If it's nazzed, are replacements available quickly?
John

^{_{Subscribers  do not see these advertisements}}

 

[wivvy's dad]

Mine ran constantly because I had a leak


But I found it pretty smart-ish

 

[johnp10]

Cheers.
No obvious leaks, but I'll look again.
Crackin avatar.
John