rollerteam 700 habitation door handle

Discussion in 'The Beginner' started by graham chesters, Oct 29, 2014.

  1. graham chesters

    graham chesters Read Only Funster

    Joined:
    Oct 29, 2014
    Messages:
    2
    Likes Received:
    0
    Location:
    dundee
    The outside door handle snapped off. I have bought the replacement , however when I try to dismantle the handle to replace it it will not separate . I and afraid to force it. Any advice please
     
  2. DanielFord

    DanielFord Funster

    Joined:
    Jun 1, 2013
    Messages:
    2,206
    Likes Received:
    2,490
    Location:
    Surrey
    I don't know the specific model, however, after first checking that you really have removed all the fixing screws/bolts I would use a mobile phone case splitter to break the sealant around the handle.
    An old credit card can also be used. If it will not budge, I would suggest you have missed a bolt somewhere.
    Sorry to be a bit vague, but hope this helps a little.
     
  3. graham chesters

    graham chesters Read Only Funster

    Joined:
    Oct 29, 2014
    Messages:
    2
    Likes Received:
    0
    Location:
    dundee
    Thanks for the reply . I have taken out all the scews and the lock/handle hangs loose but still connected on Botha sides of door. I was thinking maybe a pin in the mechanism or something. Any further thoughts. Cheers G
     
  4. DanielFord

    DanielFord Funster

    Joined:
    Jun 1, 2013
    Messages:
    2,206
    Likes Received:
    2,490
    Location:
    Surrey
    If it is like a car door handle, there will be a cir-clip holding the activating rod in place. I suspect you will not have cir-clip pliers to open them, so you will have to be creative with removing them.
     
Loading...

Share This Page