control panel fault (1 Viewer)

[haybobajob]

Hi, all

I have a swift voyager 695 EL and it has a symbol on the control panel (0) I looked in my handbook and it says the fuse is blown on the NB184 I’ve checked all fuses all ok and everything seems to be working in the motorhome. Not sure what to do next, has anyone had similar problems.
Thanks.

 

[MikeD]

Bump

 

[haybobajob]

Bump ?

^{_{Subscribers  do not see these advertisements}}

 

[tonka]

Yes.. lets' forget "hello" we just "bump".. !!!

 

[jockaneezer]

Hi and welcome.
I think I've heard others on here mention a Swift Forum on the net which might be worth a look, although someone on here may be along with an answer once they've finished their daily mail crossword.

 

[Riverbankannie]

Bump is shorthand for bumping your post up the recent list so that it might attract the attention of someone who can help you.
Sorry but I don't know the answer. If you get no luck you could try another thread with the make/model of your controller In the title.

^{_{Subscribers  do not see these advertisements}}

 

[WillH]

Hello and welcome, do you mean an NE184 panel?

 

[WillH]

Bit of a long shot but have you tried disconnecting the leisure battery for a couple of minutes then reconnecting it?

 

[haybobajob]

Hello willH
Sorry, yes I do mean the NE 184 panel
I also have tried disconnecting the battery.

^{_{Subscribers  do not see these advertisements}}

 

[gus-lopez]

 

[gus-lopez]

Have you actually checked each with a meter ? As I have had some that look perfect & yet do not have a circuit when metered.

 

[MikeD]

Yes.. lets' forget "hello" we just "bump".. !!!

Bump

"Bump" just puts you on the top of the front page again. As your post was half way down the 2nd page I thought nobody would have see it.

And welcome


- bit of a rush this morning

^{_{Subscribers  do not see these advertisements}}

 

[johnandi]

Bit of a long shot but have you tried disconnecting the leisure battery for a couple of minutes then reconnecting it?

Is that like the 'switch it off and switch it back on again' solution!

 

[Just smiffy]

Is that like the 'switch it off and switch it back on again' solution!

Ahh, but make sure you wait at least two seconds.....

 

[maxi77]

Have you actually checked each with a meter ? As I have had some that look perfect & yet do not have a circuit when metered.

Not always enough I have had one where it was partially blown, showed continuity and there was always voltage at the load end but the fuse would not carry a load.

^{_{Subscribers  do not see these advertisements}}

 

[MikeandKath]

Had various problem with my swift kontiki panel. I took panel off removed clip on wiring loom and backup battery. Waited 5 minutes reconnected wiring clip and replaced battery. No more problem. Hope this helps.