Autosleeper Smyphony fresh water tank

Discussion in 'Heating and Air-Conditioning' started by wglynr, Jul 14, 2012.

  1. wglynr

    wglynr Read Only Funster

    Joined:
    Jul 14, 2012
    Messages:
    2
    Likes Received:
    0
    Location:
    Stamford
    The ply panel that the water tank sits on between the two hangers is delaminating. Has any one got any bright ideas on a simply whay to change it. I am not keen on disconnecting the pipe work unless I have to
     
  2. aba

    aba

    Joined:
    Oct 27, 2009
    Messages:
    2,793
    Likes Received:
    1,119
    Location:
    yorkshire
    personally id remove the tank and give it a good clean at the same time.
     
    • Like Like x 1
  3. wglynr

    wglynr Read Only Funster

    Joined:
    Jul 14, 2012
    Messages:
    2
    Likes Received:
    0
    Location:
    Stamford
    Thanks ; yes it would be sensible to clean the tank, but it is rather large and was hoping to get away with out moving it. But I think I will have to as it is going to be the simplist way to get the size correct for the mounting board
     
  4. Terry

    Terry Funster

    Joined:
    Dec 27, 2007
    Messages:
    10,722
    Likes Received:
    6,224
    Location:
    South yorks
    How bad is the de-lamination ?it could well last yrs with just the edges looking scruffy :thumb: even if it fails completely (which I doubt)the straps will still hold the tank in place :BigGrin: then you can cut some new ply and watch it de-laminate again :Wink::BigGrin:
    terry
     
Loading...

Share This Page