D
Deleted member 22420
Deleted User
I’ve just purchased an Auto Trail 740 (2008) model. The previous owner has removed the dish and control box, but the dish base plate and wiring loom are in place. I’ve verified with ten Haaft that the installation is an Oyster 85cm.
Theoretically then, installing the dish and control box should be relatively simple (I’m a retired broadcast engineer). However, I’d like to ensure that the dish retracts on engine start (as a legal requirement anyway) and also locate the best 10 – 20 Amp feed for the system.
So, does anyone know the exact point to find a 12v ignition on/off feed to connect to pin 15 of the Oyster control box? I assume the best places for both feeds are from Sargent EC 325 distribution box but I'm reluctant to open it up without specific details.
Theoretically then, installing the dish and control box should be relatively simple (I’m a retired broadcast engineer). However, I’d like to ensure that the dish retracts on engine start (as a legal requirement anyway) and also locate the best 10 – 20 Amp feed for the system.
So, does anyone know the exact point to find a 12v ignition on/off feed to connect to pin 15 of the Oyster control box? I assume the best places for both feeds are from Sargent EC 325 distribution box but I'm reluctant to open it up without specific details.