icantremember
LIFE MEMBER
- Sep 2, 2010
- 8,328
- 17,540
- Funster No
- 13,512
- MH
- Hymer T-SL668
- Exp
- since 2005
My Omni step has been messing around, working sometimes and not others.
I have replaced the step with a new one but still not working.
All the batteries are fully charged.
I checked the voltage at the fuse and getting full 12.7v (also checked the fuse)
On checking voltage at the operating switch I'm only getting around 4.8v.
I am assuming there is probably a poor connection somewhere but before I try to trace the wiring would like any advice please to confirm this is the likely problem or any other ideas.
I have replaced the step with a new one but still not working.
All the batteries are fully charged.
I checked the voltage at the fuse and getting full 12.7v (also checked the fuse)
On checking voltage at the operating switch I'm only getting around 4.8v.
I am assuming there is probably a poor connection somewhere but before I try to trace the wiring would like any advice please to confirm this is the likely problem or any other ideas.