Alde 3000 (1 Viewer)

[Spencer22]

Hi does anybody have advice on fitting a Danfoss TP5000 to a Alde 3000 heating system on a Burstner A747-2 have been told that alde recommend these units which are programmable but I'm not sure where to wire to ie the boiler or existing thermostate

 

[scotjimland]

Hi does anybody have advice on fitting a Danfoss TP5000 to a Alde 3000 heating system on a Burstner A747-2 have been told that alde recommend these units which are programmable but I'm not sure where to wire to ie the boiler or existing thermostate

Hi and welcome..

as the Danfoss is a 5 day programmable room thermostat, it would be installed in place of the your existing room thermostat.

if you have not already seen it, Danfoss info here
http://heating.danfoss.co.uk/xxTypex/296432_MNU17433300_SIT313.html

 

[maz]

Hi does anybody have advice on fitting a Danfoss TP5000 to a Alde 3000 heating system on a Burstner A747-2 have been told that alde recommend these units which are programmable but I'm not sure where to wire to ie the boiler or existing thermostate

Hi and welcome to the Fun. :welcome:

I don't know about the actual wiring but I had the same programmer fitted to the same Alde boiler by Graham Cutmore (UK Number 1 Alde man). The thermostat on the Alde control panel had to be turned to maximum and then the Danfoss programmer would override it. Hope this helps.

^{_{Subscribers  do not see these advertisements}}

 

[canopus]

Maz who is Graham Cutmore when he's washed and ready for bed?

 

[Dai]

I have an upgrade planned this year wherebye I am going to have my "on" "off" heating controller on my van changed to what they are fitting on later Burstner vans. Namely the "bells and whistles" digital controller. This will enable me to programme when the heating comes on and off when the van is laid up.

Graham Cutmore comes highly recommended. He is not aware of my custom yet

Link: Broken Link Removed

Dai

 

[maz]

Maz who is Graham Cutmore when he's washed and ready for bed?

Dai has provided a link below. Graham Cutmore is based in Wellingborough but does travel. He knows everything there is to know about Alde boilers and then some. He's also a very nice man.

^{_{Subscribers  do not see these advertisements}}

 

[canopus]

Cheers Maz he might just the chap Im looking for to carry out a service on our boiler:thumb: